Radiator Cooling Fan: Service and Repair

Cooling Fan Motor and Shroud

Removal and Installation
1. Disconnect the battery ground cable. For additional information, refer to Battery.
2. Remove the air cleaner outlet pipe. For additional information, refer to Fuel Delivery and Air Induction.
3. Disconnect the 2 cooling fan motor and shroud electrical connectors.
4. Disconnect the coolant control valve jumper harness electrical connector.
5. Remove the bolt and the receiver/drier and bracket and position aside.
^ To install, tighten to 11 Nm (8 ft. lbs.).
6. Disconnect the coolant control valve electrical connector.
7. Remove the bolt and the coolant control valve and position it aside.
^ To install, tighten to 6 Nm (53 inch lbs.).
8. Remove the 2 bolts and the auxiliary coolant pump.
^ To install, tighten to 9 Nm (79 inch lbs.).
9. Remove the 2 bolts and the cooling fan motor and shroud.
^ To install, tighten to 10 Nm (89 inch lbs.).
10. To install, reverse the removal procedure.