Condenser HVAC: Service and Repair

CONDENSER CORE







Removal and Installation

NOTE: Installation of a new receiver/drier is not required when repairing the air conditioning system except when there is physical evidence of contamination from a failed A/C compressor or damage to the receiver/drier.

1. With the vehicle in NEUTRAL, position it on a hoist.
2. Recover the refrigerant.
3. Remove the center underbody deflector shield.
4. Remove the condenser inlet fitting nut.
- Discard the O-ring seal.
- To install, tighten to 8 Nm (71 lb-in).

5. Remove the 2 lower air deflector pin-type retainers.
6. Remove the lower air deflector.
7. Remove the condenser outlet fitting nut.
- Discard the O-ring seal.
- To install, tighten to 8 Nm (71 lb-in).

8. Remove the 2 condenser bolts and the condenser.
- To install, tighten to 6 Nm (53 lb-in).

9. To install, reverse the removal procedure.
- Install new O-ring seals.
- Lubricate the refrigerant system with the correct amount of clean PAG oil.

10. Evacuate, leak test and charge the refrigerant system.