Engine Control Module: Service and Repair

POWERTRAIN CONTROL MODULE (PCM)












Removal and Installation
1. Disconnect the battery ground cable.
2. Remove the cabin air filter plenum.
3. Remove the glove compartment.
4. Disconnect the 3 powertrain control module (PCM) electrical connectors.
- To install, tighten to 5 Nm (44 lb-in).

5. Remove the 2 PCM nuts.
- To install, tighten to 8 Nm (71 lb-in).

6. Remove the 2 PCM bracket bolts.
- To install, tighten to 7 Nm (62 lb-in).

7. Remove the PCM and bracket as an assembly through the glove compartment opening.
8. To install, reverse the removal procedure.