Parking Brake Release Switch: Service and Repair

Parking Brake Switch

Parking Brake Switch:

Removal and Installation

NOTE: The electronic parking brake (EPB) system must be reset following the EPB system reset procedure if the battery has been disconnected. Refer to Electronic Parking Brake (EPB) Resetting.

1. Disconnect the battery. For additional information, refer to Battery.
2. Release the floor console finish panel cup holder from the floor console finish panel and position it aside.
3. Disconnect the parking brake switch electrical connector from the parking brake switch.
4. Remove the 4 parking brake switch screws.
5. Release the parking brake switch from the floor console finish panel cup holder.
6. To install, reverse the removal procedure.