Yaw Rate Sensor: Service and Repair
Yaw Rate SensorYaw Rate Sensor:
Removal and Installation
NOTE: When installing a new yaw rate sensor, the anti-lock brake system (ABS) module must be configured (using vehicle as-built data) and calibrated. Follow the diagnostic tool directions for the calibration procedures. For module configuration, refer to Body Control Systems.
1. If equipped, remove the floor console. For additional information, refer to Console.
2. NOTE: Fold back the carpeting flap to gain access to the yaw rate sensor. Disconnect the yaw rate sensor electrical connector.
3. Remove the 2 nuts and the yaw rate sensor.
^ To install, tighten to 7 Nm (62 inch lbs.).
4. To install, reverse the removal procedure.