Driveshaft Center Bearing

Driveshaft Center Bearing

Special Tool(s):

Special Tool(s)

Disassembly
1. Remove the driveshaft.
2. Separate the front driveshaft from the rear shaft.

3. CAUTION: Do not clamp on the driveshaft tube as a fracture can result.






Position and clamp the driveshaft at the weld yoke.






4. Using the special tools, remove the retaining ring and the center bearing and bracket assembly.

Assembly






1. Position the center bearing and bracket assembly and the retaining ring on the yoke.






2. Using the special tool, drive the retaining ring and bearing assembly until fully seated on the yoke.
3. Assemble the front and rear shaft assemblies.
4. Install the driveshaft.