Front Door Window Regulator and Motor
FRONT DOOR WINDOW REGULATOR AND MOTORRemoval and Installation
1. Remove the front door window glass.
2. Remove the front door inner support bracket bolt.
- To install, tighten to 12 Nm (9 lb-ft).
3. Remove the 2 nuts and the front door inner support bracket.
- To install, tighten to 12 Nm (9 lb-ft).
4. Remove the 6 front door inner module assembly bolts.
- To install, tighten to 12 Nm (9 lb-ft).
5. If equipped, disconnect the remote keyless entry keypad electrical connector.
6. Disconnect the exterior mirror electrical connector and release the locators from the front door inner module assembly.
7. Disconnect the front door inner module assembly electrical connector, main wiring harness electrical connector and release the locators from the front door inner module assembly.
8. Remove the front door lower theft shield screw.
- To install, tighten to 10 Nm (89 lb-in).
9. Remove the nut and the lower theft shield.
10. On the LH door, disconnect the door lock cylinder actuating rod.
11. Open the clip and disconnect the exterior door handle actuating rod.
- If equipped, disconnect the door lock cylinder switch electrical connector.
12. Disconnect the front door latch electrical connector.
13. Remove the 3 door latch screws and position the door latch aside.
- To install, tighten to 12 Nm (9 lb-ft).
14. Remove the front door inner module assembly.
15. Remove the 5 nuts and the front door window regulator.
- To install, tighten to 5 Nm (44 lb-in).
16. To install, reverse the removal procedure.
- Make sure the alignment dowels are seated before installing the inner door module bolts.
- Tighten the inner door module bolts that are next to the alignment dowels first.