Fender Splash Shield - LH

FENDER SPLASH SHIELD - LH

Part 1:

Part 2:

Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the battery.
3. Remove the air cleaner.
4. Remove the bolt and position the PCM aside.
- To install, tighten to 10 Nm (89 lb-in).

5. Release the wiring harness locator from the fender splash shield.
6. Release the front ABS sensor wiring harness locator.
7. Remove the air cleaner housing insulator.
8. Remove the upper fender splash shield bolt.
- To install, tighten to 12 Nm (9 lb-ft).

9. Remove the air compressor bracket nuts.
- Install, tighten to 8 Nm (71 lb-in).

10. Disconnect the air compressor electrical connector.
11. Release the air pressure hose locator.
12. Disconnect the pin-type retainer and position the air compressor air intake aside.
13. Remove the 2 inner bolts, the pin-type retainer, and the fender splash shield.
- Install, tighten to 12 Nm (9 lb-ft).

14. To install, reverse the removal procedure.