Front Seat

FRONT SEAT







Removal

WARNING:
- Always wear safety glasses when repairing a supplemental restraint system (SRS) vehicle and when handling an air bag module. This will reduce the risk of injury in the event of an accidental deployment.
- After deployment, the air bag surface can contain deposits of sodium hydroxide, a product of the gas generant combustion that is irritating to the skin. Wash your hands with soap and water afterwards.
- Never probe the connectors on the air bag module. Doing so can result in air bag deployment, which can result in personal injury.
- To reduce the risk of personal injury, do not use any memory saver devices.

NOTE:
- If a seat equipped with a supplemental restraint system (SRS) component is being serviced, the SRS must be depowered.
- The air bag warning lamp illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
- The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
- Driver seat shown, passenger seat similar.

1. Position the seat to allow access to the front and rear retainers.
2. Depower the SRS.
3. Remove the 2 seat track-to-floor nut covers.
4. Remove the 2 seat-to-floor nuts.
- The center occupant safety belt buckle anchor can be separated from the seat track once the seat is removed.

5. Remove the 2 seat track-to-floor bolt covers.
6. Remove the 2 seat-to-floor bolts.







7. NOTE: Some component electrical connectors may or may not exist due to vehicle options.

Disconnect the electrical connectors.

8. CAUTION: Use care when handling the seat and track assembly. Dropping the assembly or sitting on a seat not secured in the vehicle can result in damaged components.

Remove the seat from the vehicle.

Installation
1. Install the seat in the vehicle.
- While installing and positioning the seat, make sure the safety belt buckle anchor is positioned to go through the seat mounting stud.







2. NOTE: Some component connectors may or may not exist due to vehicle options.

Connect the electrical connectors.

3. Install the 2 seat-to-floor bolts.
- Tighten to 25 Nm (18 lb-ft).

4. Install the 2 front seat track covers.
5. Install the inboard seat-to-floor nut.
- Before installing the rear inboard nut, make sure the center seat safety belt buckle anchor is positioned to go on the seat mounting stud.
- Tighten to 80 Nm (59 lb-ft).

6. Install the outboard seat-to-floor nut.
- Tighten to 25 Nm (18 lb-ft).

7. Install the 2 front seat track rear covers.
- Make sure the safety belts and buckles are accessible to the occupants after installation.

8. Repower the SRS.