Brake Fluid Reservoir

Brake Fluid Reservoir

Material:

Removal and Installation

WARNING: Use of any other than approved DOT 3 brake fluid will cause permanent damage to brake components and will render the brakes inoperative. Failure to follow these instructions may result in personal injury.

WARNING: Brake fluid contains polyglycol ethers and polyglycols. Avoid contact with eyes. Wash hands thoroughly after handling. If brake fluid contacts eyes, flush eyes with running water for 15 minutes. Get medical attention if irritation persists. If taken internally, drink water and induce vomiting. Get medical attention immediately. Failure to follow these instructions may result in personal injury.

CAUTION: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it with water.

1. Disconnect the brake fluid level switch electrical connector.
2. Use a suitable suction device to drain the brake master cylinder reservoir.
3. Pull upward on the brake master cylinder reservoir to remove.

4. NOTE: Whenever installing a brake master cylinder reservoir, install new grommets.

Remove the 2 brake fluid reservoir grommets.
^ To install, lubricate the 2 grommets with DOT 3 brake fluid.
5. To install, reverse the removal procedure.
^ Press the brake master cylinder reservoir into the grommets until it is fully seated.