Windshield Washer Switch: Service and Repair

Steering Column Multifunction Switch








Removal and Installation

1. Depower the supplemental restraint system (SRS).





2. Remove the ignition switch lock cylinder.
1 Position the ignition switch lock cylinder to the RUN position.
2 Using a suitable tool, push upward on the cylinder release tab while pulling the ignition switch lock cylinder outward.
3. Remove the tilt release lever/handle.

4. NOTE: Release the upper steering column shroud by pressing the sides inward.

Remove the 3 screws and the upper and lower steering column shrouds.
^ To install, tighten to 2 Nm (18 inch lbs.).
5. Disconnect the 3 multi-function switch electrical connectors.
6. Remove the 2 screws and the multi-function switch.
^ To install, tighten to 3 Nm (27 inch lbs.).
7. To install, reverse the removal procedure.
^ Repower the supplemental restraint system (SRS).