Part 2
Engine continued40. Remove the nut and disconnect the generator B+ cable.
41. Disconnect the generator electrical connector.
42. Detach the wiring harness retainer from the generator.
43. Disconnect the engine oil pressure (EOP) switch electrical connector and the wiring harness pin-type retainer.
^ Remove the wiring harness from the engine.
44. Remove the bolt and the A/C manifold.
^ Discard the O-ring seals.
45. Remove the nut, 2 bolts and the A/C compressor.
46. Remove the A/C compressor mounting stud from the oil pan.
47. Remove the bolt, nut and the generator.
48. Detach the PSP hose retainer from the engine lifting eye.
49. Remove the PSP hose bracket nut.
50. Remove the PSP tube bracket bolt from the RH cylinder head.
51. Remove the 3 bolts and the power steering pump.
52. Remove the 3 bolts and the accessory drive belt tensioner.
53. Remove the 4 nuts (3 shown) and the LH catalytic converter.
^ Discard the nuts and the gasket.
54. Remove the 3 bolts and the LH exhaust manifold heat shield.
55. Remove the 6 nuts and the LH exhaust manifold.
^ Discard the nuts and the exhaust manifold gasket.
56. Clean and inspect the LH exhaust manifold.
57. Remove and discard the 6 LH exhaust manifold studs.
FWD vehicles
58. Remove the 4 nuts and the RH catalytic converter.
^ Discard the nuts and the gasket.
All vehicles
59. Remove the 3 bolts and the RH exhaust manifold heat shield.
60. Remove the 6 nuts and the RH exhaust manifold.
^ Discard the nuts and the exhaust manifold gasket.
61. Clean and inspect the RH exhaust manifold.
62. Remove and discard the 6 RH exhaust manifold studs.
63. Remove the RH cylinder block drain plug or, if equipped, the block heater.
^ Allow coolant to drain from the cylinder block.
64. Remove the LH cylinder block drain plug.
^ Allow coolant to drain from the cylinder block.
65. Remove the pin-type retainer and the cover.
66. Remove the 2 bolts and the engine lifting eye.
67. Remove the bolt and the upper intake manifold bracket.
68. Remove the bolt and the upper intake manifold bracket.
69. Remove the bolt and the RH CMP sensor.
All wheel drive (AWD) vehicles
70. Remove the 2 bolts and the catalytic converter bracket.
All vehicles
71. Remove the 4 bolts and the fuel rail and injectors as an assembly.
72. Remove the 2 thermostat housing-to-lower intake manifold bolts.
^ Remove the thermostat housing and discard the gasket.
73. Remove the 10 bolts and the lower intake manifold.
^ Discard the gaskets.
74. Disconnect and remove the CHT sensor jumper harness.
75. Remove the bolt and the LH CMP sensor.
76. Remove the bolt and the CKP sensor.
77. Remove the EOP switch.
78. Remove the 2 bolts and the oil filter adapter.
^ Discard the gasket and the O-ring seal.
79. NOTE: LH shown, RH similar.
Remove the 6 bolts and the 6 coil-on-plugs.
