Programming and Relearning

ROOF OPENING PANEL MOTOR INITIALIZATION

CAUTION: Be sure there are no obstructions in the path of the roof opening panel glass before attempting to initialize the roof opening panel motor.

NOTE:
- A new roof opening panel motor must be initialized after installation. It will only move toward the VENT position until initialized.
- This procedure must be carried out anytime a new roof opening panel motor or roof opening panel assembly is installed.

1. Turn the ignition to the RUN position.
2. For a new roof opening panel motor, press and hold the roof opening panel control switch forward until the roof opening panel glass moves to the full VENT position.
3. Cycle the ignition from ON to OFF and then back to ON.
4. Within 5 seconds:
- press and release the roof opening panel control switch forward.
- press and hold the roof opening panel control switch forward.

5. Continue holding roof opening panel control switch forward for 5 seconds after the roof opening panel motor stops moving to confirm this position to the roof opening panel motor.

6. NOTE: Only complete open and close motions count towards the cycle count. If the roof opening panel reverses during closing operations, perform the cycles with the roof opening panel control switch continuously held during the closing motions.

Release the roof opening panel switch and test the system for normal operation by checking the one-touch open, one-touch close, one-touch vent and close operations. Five complete cycles must be carried out for the roof opening panel motor to be correctly initialized.
- If roof opening panel does not operate correctly, repeat Steps 2 through 6.