Power Window Motor: Service and Repair

WINDOW REGULATOR MOTOR

Part 1:

Part 2:

Exploded View

Removal and Installation

NOTE:
- For MKZ only, if installing a new LH or RH front window motor, it must be initialized.
- For MKZ only, the LH or RH front window motor must be de-initialized, then initialized whenever the front window motor is removed from the window regulator drum housing, a new window regulator is installed, a new window glass is installed, a new top run is installed or for any operation in which grease or lubricants are applied to the window regulator or glass run.

1. Remove the door trim panel.
2. Disconnect the window motor electrical connector.
3. Secure the glass in position with tape.







4. Remove the 3 window motor screws.
5. Remove the window motor.
6. To install, reverse the removal procedure.
- For MKZ only, if installing a new LH or RH front window motor, it must be initialized. If installing the original front window motor, it must be de-initialized, then initialized.