Part 2
EngineRemoval (Steps 31-60)
31. Remove the nut and the transmission cooler tube support bracket.
32. Remove the bolt.
33. Disconnect the crankshaft position (CKP) sensor electrical connector.
34. Position the power steering tube bracket aside.
35. Disconnect the engine wiring harness retainers from the A/C compressor.
36. Disconnect the A/C compressor electrical connector.
37. Remove the 3 bolts and position the A/C compressor aside.
38. Remove the 4 bolts and position the power steering pump aside.
39. Remove the starter motor.
^ Remove the starter motor solenoid cover.
^ Disconnect the electrical connections.
^ Remove the bolts.
^ Remove the starter motor.
40. Disconnect the RH heated oxygen sensor (HO2S) electrical connectors.
41. Disconnect the LH HO2S electrical connector.
42. Using the special tool, remove the LH HO2S.
43. Support the exhaust and remove the 4 nuts.
44. NOTE: LH shown, RH similar.
Remove the 2 engine mount nuts.
45. Install a suitable lifting device under the transmission and support.
46. Remove the rear transmission insulator nuts.
47. Raise the transmission and remove the rear transmission insulator bolts.
48. Remove the transmission rear insulator and lower the transmission down to rest on the rear crossmember.
49. Disconnect the HO2S sensor and the solenoid body sensor electrical connectors.
50. Disconnect the output shaft speed sensor, transmission range sensor and the turbine shaft speed sensor electrical connectors.
51. Release the wiring harness from the retainers on the transmission.
52. Remove the 3 bolts and the inspection cover.
53. Remove the torque converter nut access plug.
^ Remove the 4 nuts.
54. Remove the 4 bolts and 1 stud.
55. Remove the engine support insulator nuts.
56. Install the special tool to the RH cylinder head.
57. Install the special tool to the LH cylinder head.
58. Install the special tools.
59. Remove the 2 bolts.
60. Remove the engine assembly from the vehicle.
