Parking Assist Control Module: Service and Repair

PARKING AID MODULE

Removal and Installation
1. With the vehicle in NEUTRAL (N), position it on a hoist.







2. Remove the rear bumper splash shield.
- Remove the 5 screws and 2 nuts.

3. Disconnect the parking aid module.







4. Remove the 3 bolts.
- To install, tighten to 5 Nm (44 lb-in).

5. NOTE: The parking aid module can be removed from the vehicle by sliding it toward the rear of the vehicle and then around the parking aid module bracket along the rear bumper.

Remove the parking aid module.

6. To install, reverse the removal procedure.