Ignition Switch: Service and Repair

Ignition Switch

Removal and Installation








1. Depower the supplemental restraint system (SRS). For additional information, refer to Air Bag Systems.
2. Remove the tilt lever/ handle.

3. NOTE: Release the upper steering column shroud by pressing the sides inward.

Remove the 3 screws and the upper and lower steering column shrouds.
^ To install, tighten to 2 Nm (18 inch lbs).
4. Remove the ignition switch.
1 Disconnect the electrical connector.
2 Remove the ignition switch screw and remove the ignition switch.
^ To install, tighten to 5 Nm (44 inch lbs).
5. To install, reverse the removal procedure.
^ Repower the SRS. For additional information, refer to Air Bag Systems.