Heated Glass Element: Testing and Inspection

COMPONENT TESTS

Grid Wire Test
1. Using a bright lamp inside the vehicle, inspect the wire grid from the outside. A broken grid wire appears as a brown spot.
2. Run the engine at idle. Set the heated rear window control switch to on. The indicator light should come on.
3. Working inside the vehicle with a voltmeter, connect the broad red-brown stripes of the heated rear window positive lead to battery side and negative lead to ground side. The meter should read 10-13 volts. A lower voltage reading indicates a loose ground connection.
4. Contact a good ground point to the negative lead of the meter. The voltage reading should not change.
5. With the negative lead of the meter grounded, touch each grid line of the heated rear window glass at its midpoint with the positive lead. A reading of approximately 6 volts indicates the line is good. A reading of zero volts indicates the line is broken between the midpoint and the B+ side of the grid line. A reading of 12 volts indicates the circuit is broken between the midpoint of the grid line and ground.
6. Pinpointing the exact position of the break can be accomplished (if the voltmeter reads 0 volts when the midpoint of the grid line is touched with the positive lead of the voltmeter) by moving the positive lead of the voltmeter toward the B+ side of the grid line and touching the grid line until the voltmeter reads 6 volts.

If the voltmeter reads 12 volts when the midpoint of the grid line is touched with the positive lead of the voltmeter, simply move the positive lead of the voltmeter toward the ground connection of the grid line and touch the grid line until the voltmeter reads 6 volts.