Universal Serial Bus (USB) Cable and Port

Universal Serial Bus (USB) Cable and Port

Universal Serial Bus (USB) Port and Cable Upper View










Universal Serial Bus (USB) Port and Cable Lower View









Removal and Installation

1. Remove the floor console.

2. Remove the LH and RH floor console finish mouldings.
- Using a suitable tool such as a trim removal tool, pry upward to disengage the clips.





3. Remove the floor console rear panel by pulling straight rearward to disengage the clips.

4. Remove the 5 screws and the floor console stowage bin door.

5. NOTE: Release the rear clips of the LH and RH floor console upper trim panels (located along the top-outer edges of the floor console) to gain access to the floor console stowage bin screws.

Remove the 2 screws and the floor console stowage bin.

- Disconnect the Universal Serial Bus (USB) port and cable from the floor console stowage bin.

6. Remove the 4 screws and the Accessory Protocol Interface Module (APIM) and bracket as an assembly.
- Disconnect the USB port and cable from the APIM.

7. Release the push-pins and remove the USB port and cable.

8. To install, reverse the removal procedure.