Pinpoint Test AG: DTC B19A6
Seats
Pinpoint Tests
Pinpoint Test AG: DTC B19A6
Refer to Wiring Diagram Set 119, Climate Controlled Seats for schematic and connector information. Diagrams By Number
Normal Operation
The Dual Climate Controlled Seat Module (DCSM) supplies a speed control signal voltage to the passenger seat backrest Thermo-Electric Device (TED) on circuit VHS21 (BU/WH). The TED blower is supplied operating voltage from DCSM output circuit CHS08 (BN/YE) and ground from DCSM output circuit RHS08 (VT/WH).
- DTC B19A6 Passenger Seat Back Blower Speed Short to Ground - If the passenger seat backrest blower speed circuit is shorted to ground, the DCSM will shut down the passenger seat system and set this DTC.
This pinpoint test is intended to diagnose the following:
- Wiring, terminals or connectors
- TED and blower assembly
- DCSM
PINPOINT TEST AG: DTC B19A6
NOTICE: When taking measurements at Dual Climate Controlled Seat Module (DCSM) harness connectors, do not insert the electrical probes into the female connector pins. Inserting the probes into connector pins can cause intermittent or open electrical connections after reassembly resulting in Diagnostic Trouble Codes (DTCs) and system failure. Touching the tip of these connector pins is recommended instead.
NOTE: The air bag warning indicator illuminates when the correct Restraints Control Module (RCM) fuse is removed and the ignition is ON.
NOTE: The Supplemental Restraint System (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.
-------------------------------------------------
AG1 CHECK BACKREST TED BLOWER SPEED CONTROL CIRCUIT FOR A SHORT TO GROUND
- Ignition OFF.
- Depower the SRS. Refer to Supplemental Restraint System (SRS) Depowering and Repowering in the General Procedures portion of Air Bag Systems.
- Disconnect: Passenger Seat Side Air Bag C3133.
- Disconnect: Passenger Safety Belt Buckle Pretensioner C3066.
- Disconnect: DCSM C3265c.
- Disconnect: Backrest TED C3039.
- Measure the resistance between DCSM C3265c-4, circuit VHS21 (BU/WH), harness side and ground.
- Is the resistance greater than 10,000 ohms?
Yes
GO to AG2.
No
REPAIR the circuit. REPEAT the self-test. CLEAR the DTCs.
DISCONNECT the battery ground cable.
CONNECT passenger safety belt buckle pretensioner C3066.
CONNECT passenger seat side air bag module C3133.
REPOWER the SRS. REFER to Air Bag Systems.
-------------------------------------------------
AG2 CHECK BACKREST TED BLOWER SPEED CONTROL CIRCUIT AND BLOWER GROUND CIRCUIT FOR A SHORT TOGETHER
- Measure the resistance between DCSM C3265c-4, circuit VHS21 (BU/WH), harness side and C3265c-7, circuit RHS08 (VT/WH), harness side.
- Is the resistance greater than 10,000 ohms?
Yes
GO to AG3.
No
REPAIR the circuits. REPEAT the self-test. CLEAR the DTCs.
DISCONNECT the battery ground cable.
CONNECT passenger safety belt buckle pretensioner C3066.
CONNECT passenger seat side air bag module C3133.
REPOWER the SRS. REFER to Air Bag Systems.
-------------------------------------------------
AG3 DETERMINE BACKREST TED OR DCSM FAILURE
- Remove the backrest TED from the passenger seat. Refer to Seat Backrest Thermo-Electric Device Seat Backrest Thermo-Electric Device.
- Remove the backrest TED from the driver seat and install it on the passenger seat.
- Connect: Backrest TED C3039.
- Connect: DCSM C3265c.
- WARNING: Make sure no one is in the vehicle and there is nothing blocking or placed in front of any air bag module when the battery is connected. Failure to follow these instructions may result in serious personal injury in the event of an accidental deployment.
- Connect the battery ground cable.
- Start the engine and check operation of the passenger seat climate controlled seat system.
- Does the seat operate with the TED from the other seat installed?
Yes
INSTALL a new backrest TED. REFER to Seat Backrest Thermo-Electric Device Seat Backrest Thermo-Electric Device. REPEAT the self-test. CLEAR the DTCs.
DISCONNECT the battery ground cable.
CONNECT passenger safety belt buckle pretensioner C3066.
CONNECT passenger seat side air bag module C3133.
REPOWER the SRS. REFER to Air Bag Systems.
No
INSTALL a new DCSM. REFER to Dual Climate Controlled Seat Module (DCSM) Dual Climate Controlled Seat Module (DCSM). REPEAT the self-test. CLEAR the DTCs.
DISCONNECT the battery ground cable.
CONNECT passenger safety belt buckle pretensioner C3066.
CONNECT passenger seat side air bag module C3133.
REPOWER the SRS. REFER to Air Bag Systems.
-------------------------------------------------