Pinpoint Tests AT: DTC U0151:00

Instrumentation, Message Center and Warning Chimes

Pinpoint Tests

Pinpoint Test AT: DTC U0151:00

Normal Operation
- DTC U0151:00 (Lost Communication With Restraints Control Module: No Sub-Type Information) - sets in the Instrument Panel Cluster (IPC) if data messages received from the Restraints Control Module (RCM) over the High Speed Controller Area Network (HS-CAN) are missing. For a complete list of all network messages, refer to Information Bus.

This pinpoint test is intended to diagnose the following:

- RCM
- IPC



PINPOINT TEST AT: DTC U0151:00

-------------------------------------------------
AT1 VERIFY THE CUSTOMER CONCERN


- Ignition ON.
- Verify that there is an observable symptom present.
- Is an observable symptom present?

Yes
GO to AT2.

No
The system is operating normally at this time. The DTC may have been set due to high network traffic or intermittent fault condition.

-------------------------------------------------
AT2 CHECK THE COMMUNICATION NETWORK


- Ignition ON.
- Enter the following diagnostic mode on the scan tool: Network Test.
- Carry out the network test.
- Does the RCM pass the network test?

Yes
GO to AT3.

No
REFER to Information Bus.

-------------------------------------------------
AT3 RETRIEVE THE RECORDED DTCs FROM THE IPC SELF-TEST


- Check for recorded DTCs from the IPC self-test.
- Is DTC U3003:16 or U3003:17 recorded?

Yes
Go To Pinpoint Test BC (U3003:16) or Go To Pinpoint Test BD (U3003:17). Pinpoint Tests BC: DTC U3003:16 Pinpoint Tests BD: DTC U3003:17

No
GO to AT4.

-------------------------------------------------
AT4 RECHECK THE IPC DTCs


NOTE: If new modules were installed prior to the DTC being set, the module configuration may be incorrectly set during the Programmable Module Installation (PMI) or the PMI may not have been carried out.

- Clear the DTCs. Repeat the IPC self-test.
- Is DTC U0151:00 still present?

Yes
GO to AT5.

No
The system is operating correctly at this time. The DTC may have been set due to high network traffic or intermittent fault condition.

-------------------------------------------------
AT5 CHECK FOR DTC U0151 SET IN OTHER MODULES


- Clear all DTCs.
- Ignition OFF.
- Ignition ON.
- Wait 10 seconds.
- Enter the following diagnostic mode on the scan tool: Self-Test.
- Retrieve the continuous memory DTCs from all modules.
- Is DTC U0151 set in the Occupant Classification System Module (OCSM)?

Yes
INSTALL a new RCM. CLEAR the DTCs. REPEAT the self-test.

No
INSTALL a new IPC. REFER to Instrument Panel Cluster (IPC) Instrument Panel Cluster (IPC). TEST the system for normal operation.

-------------------------------------------------