Pinpoint Tests AW: DTC U0163:00

Instrumentation, Message Center and Warning Chimes

Pinpoint Tests

Pinpoint Test AW: DTC U0163:00

Normal Operation
- DTC U0163:00 (Lost Communication With Navigation Control Module: No Sub-Type Information) - sets in the Instrument Panel Cluster (IPC) if data messages received from the Audio Control Module (ACM) over the High Speed Controller Area Network (HS-CAN) are missing. For a complete list of all network messages, refer to Information Bus.

This pinpoint test is intended to diagnose the following:

- ACM
- IPC



PINPOINT TEST AW: DTC U0163:00

-------------------------------------------------
AW1 VERIFY THE CUSTOMER CONCERN


- Ignition ON.
- Verify that there is an observable symptom present.
- Is an observable symptom present?

Yes
GO to AW2.

No
The system is operating normally at this time. The DTC may have been set due to high network traffic or intermittent fault condition.

-------------------------------------------------
AW2 CHECK THE COMMUNICATION NETWORK


- Ignition ON.
- Enter the following diagnostic mode on the scan tool: Network Test.
- Carry out the network test.
- Does the ACM pass the network test?

Yes
GO to AW3.

No
REFER to Information Bus.

-------------------------------------------------
AW3 RETRIEVE THE RECORDED DTCs FROM THE IPC SELF-TEST


- Check for recorded DTCs from the IPC self-test.
- Is DTC U3003:16 or U3003:17 recorded?

Yes
Go To Pinpoint Test BC (U3003:16) or Go To Pinpoint Test BD (U3003:17). Pinpoint Tests BC: DTC U3003:16 Pinpoint Tests BD: DTC U3003:17

No
GO to AW4.

-------------------------------------------------
AW4 RECHECK THE IPC DTCs


NOTE: If new modules were installed prior to the DTC being set, the module configuration may be incorrectly set during the Programmable Module Installation (PMI) or the PMI may not have been carried out.

- Clear the DTCs. Repeat the IPC self-test.
- Is DTC U0163:00 still present?

Yes
INSTALL a new ACM. CLEAR the DTCs. REPEAT the IPC self-test.

If DTC U0163:00 is still present, INSTALL a new IPC. REFER to Instrument Panel Cluster (IPC) Instrument Panel Cluster (IPC). TEST the system for normal operation.

No
The system is operating correctly at this time. The DTC may have been set due to high network traffic or intermittent fault condition.

-------------------------------------------------