Toe Adjustment - Rear

Toe Adjustment - Rear

1. Using alignment equipment and the manufacturer's instructions, measure the rear toe.

2. Start the engine and center the steering wheel.

3. Turn the engine OFF and, using a suitable steering wheel holding device, lock the steering wheel in the straight-ahead position.

4. Loosen the tie-rod jam nuts.





5. Rotate the toe link adjusting rod until the toe setting is within specifications.





6. NOTE: Do not allow the adjusting rod to rotate while tightening the jam nuts.

Tighten the tie-rod jam nuts to 80 Nm (59 lb-ft).

7. Recheck the rear toe and adjust as necessary.