5000 MI or 8000 KM

Lubricate
    Control Arm
      If equipped with Zerk fittings for Special Operating Conditions I. Lubricate as needed if equipped with Zerk fittings for Special Operating Conditions O.
    Ball Joint
      If equipped with Zerk fittings for Special Operating Conditions I. Lubricate as needed if equipped with Zerk fittings for Special Operating Conditions O.
Inspect
    Universal Joint, Half Shaft/Short Shaft
      Inspect and lubricate U-joints as required, if using Special Operating Conditions O. Inspect and lubricate U-joints every 5,000 miles or 6 months, if using Special Operating Conditions T, I, or D.
    Universal Joint, Drive/Propeller Shaft
      Inspect and lubricate U-joints as required, if using Special Operating Conditions O. Inspect and lubricate U-joints every 5,000 miles or 6 months, if using Special Operating Conditions T, I, or D.
Replace
    Oil Filter, Engine
      Change engine oil filter every 5,000 miles or 6 months, if using Special Operating Conditions T, I, D and O.
    Engine Oil
      Change engine oil every 5,000 miles or 6 months, if using Special Operating Conditions T, I, D and O.
    Cabin Air Filter / Purifier
      Replace cabin air filter as required (if equipped) if using Special Operating Conditions I, D and O if applicable.
    Air Filter Element
      If using Special Operating Condition D as required.
Rotate
    Tires
      Rotate tires, inspect tires for wear, measure tread depth and inspect wheel ends for end play and noise. Vehicles with dual rear wheels should only rotate if unusual wear is noted. For vehicles with different front-to-rear tire pressures, the tire pressure must be adjusted and the tire pressure sensor training must be done. If using Special Operating Conditions T, I, D, O or E.