Electronic Brake Control Module: Service and Repair

Anti-Lock Brake System (ABS) Module









Removal and Installation

NOTICE: Electronic modules are sensitive to electrical charges. The Anti-lock Brake System (ABS) module can be damaged if exposed to these charges.

1. NOTE: When installing a new ABS module, it must be configured using vehicle as-built data. For additional information, refer to Programmable Module Installation (PMI) in Information Bus. Programming and Relearning

Remove the Hydraulic Control Unit (HCU). For additional information, refer to Hydraulic Control Unit (HCU) Service and Repair.

2. Remove and discard the 4 screws.
- To install, tighten the new screws to 3 Nm (27 lb-in).

3. Remove the ABS module.

4. To install, reverse the removal procedure.