Battery Cable: Service and Repair

Battery Cables









Removal and Installation

1. Remove the battery tray. For additional information, refer to Battery Tray Battery Tray.

2. Remove the bolt and position the battery cable body ground terminal aside.
- To install, tighten to 12 Nm (106 lb-in).

3. Remove the nut and position the Battery Junction Box (BJB) cable terminal aside.
- To install, tighten to 8 Nm (71 lb-in).

4. Remove the starter solenoid terminal cover.

5. Remove the starter solenoid terminal nut and position the battery cable starter solenoid terminal aside.
- To install, tighten to 12 Nm (106 lb-in).

6. Remove the starter B+ nut and position the battery cable starter motor terminal aside.
- To install, tighten to 6 Nm (53 lb-in).

7. Release the battery cable locator from the engine.

8. Remove the bolt and position the battery cable engine ground terminal aside.
- To install, tighten to 12 Nm (106 lb-in).

9. Release the battery cable from the top of the intake manifold.

10. Release the 3 battery cable locators from the LH valve cover.

11. Position the generator protective cover aside, remove the nut and position the generator B+ terminal aside.
- To install, tighten to 17 Nm (150 lb-in).

12. Remove the battery cables.

13. To install, reverse the removal procedure.