Wiper Mounting Arm and Pivot Shaft

Wiper Mounting Arm and Pivot Shaft

Removal

1. Remove the cowl panel grille.

2. NOTICE: Do not remove the wiper motor linkage arm from the wiper motor assembly. If the arm is removed, the wiper arms may not park in the correct location and damage may occur.

Turn and position the wiper mounting arm and wiper pivot shaft assembly as shown.





3. Remove the 3 wiper mounting arm and wiper pivot shaft assembly bolts.





4. Disconnect the electrical connector.
- Detach the wire harness pin-type retainer.

5. Remove the wiper mounting arm and wiper pivot shaft assembly from the vehicle.

Installation

1. NOTICE: Do not remove the wiper motor linkage arm from the wiper motor assembly. If the arm is removed, the wiper arms may not park in the correct location and damage may occur.

If installing a new wiper mounting arm and wiper pivot shaft assembly or a new wiper motor, position the wiper motor linkage arm and wiper pivot shaft assembly to match the position of the old wiper motor linkage arm and wiper pivot shaft assembly.

2. Position the wiper mounting arm and wiper pivot shaft assembly onto the vehicle.

3. Connect the electrical connector.
- Attach the wire harness pin-type retainer.

4. Install the 3 wiper mounting arm and wiper pivot shaft assembly bolts.
- Tighten to 8 Nm (71 lb-in).





5. Cycle the wiper motor to the PARK position.

6. Install the cowl panel grille.