Knock Sensor: Service and Repair

Knock Sensor (KS)













Removal and Installation

1. Remove the thermostat housing.

2. Remove the lower intake manifold.

3. Remove the coolant tube.
- Discard the O-ring seal.

4. Disconnect the Knock Sensor (KS) electrical connector.

5. NOTICE: Only use hand tools when removing or installing the Knock Sensor (KS) or damage to the KS can occur.

Remove the 2 bolts and the KS.
- To install, tighten to 20 Nm (177 lb-in).

6. To install, reverse the removal procedure.
- Lubricate the new O-ring seal with clean engine coolant.