Steering Wheel: Service and Repair

Steering Wheel









Removal and Installation

NOTICE: Do not allow the clockspring to rotate while the steering wheel is disconnected or damage to the clockspring may result. If there is evidence that the clockspring has rotated, the clockspring must be recentered. For additional information, refer to Air Bag Systems.

1. Position the steering wheel in the straight-ahead position and turn the ignition switch to the OFF position.
- Remove the key.

2. Remove the driver air bag module. For additional information, refer to Air Bag Systems.

3. NOTE: Mark the steering wheel and column shaft for reference during installation.

Remove the steering wheel nut.

- To install, tighten to 35 Nm (26 lb-ft).

4. NOTICE: Do not remove the steering wheel by hitting the shaft with a hammer. Damage to the column may occur.

Using a suitable puller, remove the steering wheel.

- Disconnect the steering wheel switches electrical connector from the clockspring.

- Route the 2 driver air bag module electrical connectors and harness through the steering wheel.

5. Tape the clockspring center rotor to the outer housing to keep it from rotating.





6. To install, reverse the removal procedure.
- Align the steering wheel using the reference mark.

7. Install the driver air bag module. For additional information, refer to Air Bag Systems.