Seat Track

Seat Track

Removal and Installation

All seats

1. Remove the front seat backrest. For additional information, refer to Seat Backrest - Front, Without Fold Flat Seat Backrest - Front, Without Fold Flat or Seat Backrest - Front, With Fold Flat Seat Backrest - Front, With Fold Flat.

Passenger seat with failed horizontal motor

2. To remove the Occupant Classification Sensor (OCS) weight sensor assemblies, remove the 2 seat track horizontal drive unit bolts. This will allow the power seat tracks to move manually for access to the 8 OCS weight sensor assembly bolts.





Passenger seat receiving a new seat track

3. Remove the inboard and outboard OCS weight sensor assemblies. For additional information, refer to Occupant Classification Sensor (OCS) in Air Bag Systems.

Power seat

4. If equipped, disconnect the seat control switch and remove the cushion side shield.

Heated seat

5. NOTE: Passenger seat shown, driver seat similar.

Disconnect the cushion heater mat electrical connector.





All seats

6. Detach the hook-and-loop strips from around the safety belt buckle assembly.

7. Detach all wiring harness pin-type retainers from the cushion frame.

8. Release the cushion trim cover J-clips and remove the seat cushion foam pad and cushion trim cover.

Climate controlled seat

9. NOTICE: Inspect the climate controlled seat cushion manifold and foam pad for crush or obstruction before installation and repair as needed.

NOTE: Covering the Thermo-Electric Device (TED) openings is recommended to prevent foreign material from entering the TED.

Disconnect the TED assembly electrical connector.

All seats

10. Remove the 4 cushion frame-to-seat track nuts and separate the cushion frame and seat track.
- To install, tighten to 36 Nm (27 lb-ft).

11. Detach any remaining wiring harness retainers attached to the cushion frame and remove the seat track.

12. To install, reverse the removal procedure.