Alternator: Service and Repair

Generator - 3.5L













Removal and Installation

1. Remove the A/C compressor.

2. Disconnect the battery.

3. Position the generator protective cover aside, remove the nut and position the generator B+ terminal aside.
- To install, tighten to 12 Nm (106 lb-in).

4. Disconnect the generator electrical connector.
- Detach the pin-type retainer and wiring harness.

5. Remove the oil filter.
- Lubricate the oil filter seal with clean engine oil before installation.

6. Position the engine wiring harness aside.

7. Remove the generator stud nut.
- To install, tighten to 47 Nm (35 lb-ft).

8. Remove the generator bolt and the generator.

9. To install, reverse the removal procedure.