Speed Control Deactivator Switch

Speed Control Deactivator Switch









Removal

NOTICE: Do not press the pedal down when removing or installing the speed control deactivator switch, as the switch will be damaged.

1. Disconnect the speed control deactivator switch electrical connector

2. Rotate counterclockwise 45 degrees and remove the speed control deactivator switch.

Installation

NOTE: The speed control deactivator switch is self-adjusting. Do not pull-up or push-down on the brake pedal during installation. The switch only self-adjusts one time for the initial installation. If further adjustment becomes necessary, a new switch must be used.

1. Install the speed control deactivator switch, and rotate clockwise 45 degrees.

2. Connect the speed control deactivator switch electrical connector.