Pinpoint Test D: DTC U1059

Driver Door Module (DDM)

Pinpoint Tests


Pinpoint Test D: DTC U1059

Normal Operation
- DTC U1059 (SCP (J1850) Invalid or Missing Data for Transmission / Transaxle / PRNDL) - set by the Driver Door Module (DDM) whenever it receives invalid data within the PRNDL status message, or if the PRNDL status message is missing for 5 seconds or greater received over the Standard Corporate Protocol (SCP) network.

This pinpoint test is intended to diagnose the following:


- Module communication
- DDM
- Instrument Cluster (IC)



PINPOINT TEST D: DTC U1059

-------------------------------------------------
D1 VERIFY CUSTOMER CONCERN


- Ignition ON.
- Verify that there is an observable symptom present.
- Is an observable symptom present?

Yes
GO to D2.

No
The system is operating normally at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.

-------------------------------------------------
D2 CHECK THE COMMUNICATION NETWORK


- Ignition ON.
- Enter the following diagnostic mode on the scan tool: Network Test.
- Carry out the network test.
- Does the DDM and the IC pass the network test?

Yes
GO to D3.

No
REFER to Information Bus.

-------------------------------------------------
D3 RETRIEVE THE RECORDED DTCs FROM THE SELF-TEST


- Check for recorded DDM DTCs from the self-test.
- Is DTC B1317 or B1318 recorded?

Yes
For DTC B1317, Go To Pinpoint Test a. Pinpoint Test A: DTC B1317

For DTC B1318, Go To Pinpoint Test b. Pinpoint Test B: DTC B1318

No
GO to D4.

-------------------------------------------------
D4 RECHECK THE DDM DTCs


NOTE: If new modules were installed prior to the DTC being set, the module configuration may be incorrectly set during Programmable Module Installation (PMI) or the PMI may not have been carried out.

- Clear the DTCs. Repeat the DDM self-test.
- Is DTC U1059 still present?

Yes
INSTALL a new DDM. REFER to Driver Door Module (DDM) Service and Repair. TEST the system for normal operation. REPEAT the DDM self-test.

If DTC U1059 is still present, INSTALL a new Instrument Cluster (IC). REFER to Instrument Panel, Gauges and Warning Indicators.

No
The system is operating normally at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.

-------------------------------------------------