Pinpoint Test G: DTC U1059

Lighting Control Module (LCM)

Pinpoint Tests


Pinpoint Test G: DTC U1059

Normal Operation
- DTC U1059 (SCP (J1850) Invalid or Missing Data for Transmission / Transaxle / PRNDL) - set by the Lighting Control Module (LCM) whenever it receives invalid data within the PRNDL status message, or if the PRNDL status message is missing for 5 seconds or greater received over the Standard Corporate Protocol (SCP) network.

This pinpoint test is intended to diagnose the following:


- Module communication
- LCM
- Instrument Cluster (IC)



PINPOINT TEST G: DTC U1059

-------------------------------------------------
G1 VERIFY CUSTOMER CONCERN


- Ignition ON.
- Verify that there is an observable symptom present.
- Is an observable symptom present?

Yes
GO to G2.

No
The system is operating normally at this time. The DTC may have been set due to high network traffic or intermittent fault condition.

-------------------------------------------------
G2 CHECK THE COMMUNICATION NETWORK


- Ignition ON.
- Enter the following diagnostic mode on the scan tool: Network Test.
- Carry out the network test.
- Does the LCM and the IC pass the network test?

Yes
GO to G3.

No
REFER to Information Bus.

-------------------------------------------------
G3 RECHECK THE LCM DTCs


NOTE: If new modules were installed prior to the DTC being set, the module configuration may be incorrectly set during Programmable Module Installation (PMI) or the PMI may not have been carried out.

- Clear the DTCs. Repeat the LCM self-test.
- Is DTC U1059 still present?

Yes
INSTALL a new LCM. REFER to Lighting Control Module (LCM) Service and Repair. TEST the system for normal operation. REPEAT the LCM self-test.

If DTC U1059 is still present, INSTALL a new Instrument Cluster (IC). REFER to Instrument Panel, Gauges and Warning Indicators.

No
The system is operating correctly at this time. The DTC may have been set due to high network traffic or intermittent fault condition.

-------------------------------------------------