Procedures

Seat Armrest Locking Pin Reset

1. If equipped, insert a suitable tool into the LH pivot cover and attempt (push in) to reset the seat armrest locking pin. If the cover does not reset, proceed to Step 2.





2. NOTICE: Note the location of the pivot screw cover release tabs and use care when detaching the trim cover to avoid damaging the seat armrest upholstery.

Position the driver seat forward and remove the LH pivot screw cover to access the armrest impact locking pin.

1. Insert a suitable tool behind the cover and carefully pry to release the lower tab.

2. Apply upward pressure to the forward edge of the cover to release the upper tab.

3. Pull the forward edge of the cover outward and slide out the rear tab.





3. Push the armrest locking pin inward to the reset position and raise the seat armrest to the upright position.





4. After the armrest locking pin is reset, quickly rock the armrest back and forth to make sure the locking pin remains in the reset position.
- If the armrest locking pin releases, causing the armrest to lock in the upright position, a new seat armrest must be installed. For additional information, refer to Seat Armrest - Front Seat Armrest - Front.





5. Install the LH armrest pivot screw cover.
- Check the pivot screw cover tabs. If damaged, install a new cover.