Condenser to Evaporator Line

Condenser to Evaporator Line













Removal and Installation

1. Recover the refrigerant.

2. Remove the condenser outlet fitting nut and disconnect the fitting.
- Discard the O-ring seal and gasket seal.

- To install, tighten to 15 Nm (133 lb-in).

3. Disconnect the evaporator core inlet fitting.
- Discard the O-ring seals.

4. Remove the condenser-to-evaporator line.

5. To install, reverse the removal procedure.
- Install a new gasket seal and O-ring seals.

- Lubricate the refrigerant system with the correct amount of clean PAG oil.

6. Evacuate, leak test and charge the refrigerant system.