Pinpoint Tests

Suspension System


Pinpoint Tests

Pinpoint Test A: Vehicle Drifts/Pulls

This pinpoint test is intended to diagnose the following:
- Unevenly loaded vehicle
- Tire pressure
- Tire forces
- Brake drag
- Incorrect vehicle alignment
- Steering system



PINPOINT TEST A: VEHICLE DRIFTS/PULLS

-------------------------------------------------
A1 CHECK FOR UNEVENLY LOADED VEHICLE


- Visually check the vehicle for an uneven loading condition.
- Is the vehicle unevenly loaded?

Yes
ADVISE the customer of uneven loading condition.

No
GO to A2.

-------------------------------------------------
A2 CHECK THE TIRE PRESSURE


- Check the tire pressures. Refer to the Vehicle Certification (VC) label located on the driver door jamb.
- Is the tire pressure OK?

Yes
GO to A3.

No
ADJUST the tire pressures to the specified pressure.

-------------------------------------------------
A3 ISOLATE TIRE PULL CONDITION


- Cross-rotate the wheel and tire assemblies from front-to-rear.
- Does the vehicle pull/drift?

Yes
GO to A4.

No
The concern has been corrected.

-------------------------------------------------
A4 CHECK FOR BRAKE DRAG


- Spin all 4 wheel and tire assemblies by hand and check for brake drag.
- Does the wheel spin freely?

Yes
GO to A5.

No
REFER to Brakes and Traction Control to diagnose brake drag condition. Symptom Related Diagnostic Procedures

-------------------------------------------------
A5 CHECK THE WHEEL ALIGNMENT


- Using alignment equipment and the manufacturer's instructions, check the wheel alignment.
- Is the wheel alignment within specification?

Yes
REFER to Steering to diagnose steering system drift/pull condition. Symptom Related Diagnostic Procedures

No
ADJUST the alignment as necessary. REFER to General Procedures.

-------------------------------------------------