Selector Lever Cable Adjustment

Selector Lever Cable Adjustment

1. With the vehicle in NEUTRAL, position it on a hoist.

2. Place the selector lever in the (D) position.

3. Hang a 1.4 kg (3 lb) weight on the selector lever.

4. Remove the selector lever cable retaining nut and disconnect the selector lever cable from the manual control lever.





5. Position the manual control lever in the (D) position.

1. Pull the manual control lever forward until travel stops.

2. Push the manual control lever backward 2 detents to the (D) position.





6. Connect the selector lever cable to the manual control lever and install the selector lever cable retaining nut.
- Tighten to 30 Nm (22 lb-ft).





7. Remove the weight.

8. Move the selector lever from detent to detent and compare it with the transmission setting. Verify that the engine will start in P and N and that the reversing lamps illuminate in R. If not, repeat the adjustment procedure.

9. Check that the Transmission Range (TR) sensor adjustment is correct. Adjust the TR sensor if necessary.