Windshield Washer Pump: Service and Repair

Washer Pump and Reservoir





Removal and Installation

1. Remove the bolt and position the windshield washer reservoir aside.

2. Disconnect the windshield washer pump electrical connector.

3. Disconnect the windshield washer fluid level sensor electrical connector.

4. WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice. For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury.

NOTE: Windshield washer fluid should be collected in a container after the windshield washer hose is disconnected.

Remove the windshield washer reservoir.
- Disconnect the windshield washer hose.

5. Remove the windshield washer pump.

6. NOTICE: Do not operate the windshield washer pump prior to filling the windshield reservoir. Failure to follow this instruction may result in premature pump failure.

To install, reverse the removal procedure.