Keyless Entry Key-Pad: Service and Repair
Keyless Entry Keypad
Removal and Installation
WARNING: Disconnect the window regulator motor connector before working inside the vehicle doors. Service actions inside the door (such as door latch, handle or lock cylinder service) or operating the remote keyless entry (RKE) fob may activate the windows on vehicles equipped with global open/close. Serious injury to hands or arms may occur if a window motor is activated during service. Failure to follow these instructions may result in serious personal injury.
NOTE: The door glass must be completely raised.
1. Remove the front door trim panel.
2. Position the water shield aside.
3. Disconnect the window regulator motor electrical connector.
4. Remove the door lock cylinder. For additional information, refer to Door Lock Cylinder Service and Repair.
5. Remove the exterior mirror. For additional information, refer to Mirrors.
6. Disconnect the front door latch actuator electrical connector.
7. Remove the door lock rod extension from the rod.
8. Push the door lock rod and grommet through the door panel.
9. Unclip the inside door handle cable from the door panel.
10. Remove the door latch carrier screw.
11. Loosen the exterior door handle reinforcement bolt.
- To install, tighten to 8 Nm (71 lb-in).
12. Slide the exterior front door handle reinforcement to the front of the vehicle and push inside the door.
13. Remove the 3 front door latch bolts.
- To install, tighten to 12 Nm (106 lb-in).
14. Lower the complete latch, carrier, and handle reinforcement assembly down into the door.
15. Disconnect the keyless entry keypad electrical connector and unclip the harness from the door.
16. Insert a thin bladed tool between the window glass moulding and the door to release the tab.
17. Lift up and remove the exterior window glass moulding.
18. NOTE: The keyless entry keypad is attached to the door with double-sided tape and 3 clips.
Remove the keyless entry keypad.
19. To install, reverse the removal procedure.