Audio Control Module (ACM)

Audio Control Module (ACM)









Removal and Installation

All vehicles

NOTE: The Audio Control Module (ACM) and the Front Controls Interface Module (FCIM) are serviced separately. For additional information on the removal of the FCIM, refer to Front Controls Interface Module (FCIM) - Without Navigation Front Controls Interface Module (FCIM) - Without Navigation or Front Controls Interface Module (FCIM) - With Navigation Front Controls Interface Module (FCIM) - With Navigation.

1. NOTE: Module configuration is required when a new ACM is being installed.

Upload the ACM configuration information to the scan tool. For additional information, refer to Programmable Module Installation (PMI) in Information Bus. Programmable Module Installation (PMI)

2. Remove the RH instrument panel finish applique. For additional information, refer to Instrument Panel - Exploded View in Instrument Cluster / Carrier &/or Interior Moulding / Trim.

3. Remove the LH and RH floor console finish mouldings.
- Using a suitable tool such as a trim removal tool, pry upward to disengage the clips.





4. Remove the floor console upper finish panel.
- Using a suitable tool, pry upward to disengage the clips.





5. Remove the 2 screws and the floor console cup holder.





6. NOTE: The shifter knob is shown removed for clarity.

Remove the 4 selector lever trim panel screws, and slide the trim panel rearward to disengage the clips.





Vehicles without navigation

7. Remove the 6 screws and the HVAC module.





Vehicles with navigation

8. Remove the 4 screws and the floor console front finish panel.





All vehicles

9. Remove the 4 screws and the ACM.
- Disconnect the electrical connectors and the antenna lead-in cable.

10. To install, reverse the removal procedure.
- Download the configuration information to the ACM. For additional information, refer to PMI in Information Bus. Programmable Module Installation (PMI)