Driver Seat Module (DSM)

Driver Seat Module (DSM)









Removal and Installation

1. NOTE: This step is necessary only if the Driver Seat Module (DSM) is being replaced.

NOTE: Prior to the replacement of the module, it is necessary to upload the module configuration information to the scan tool. This information must be downloaded into the new module after installation. For additional information, refer to Information Bus.

Upload the module configuration information from the DSM. For additional information, refer to Information Bus.

2. NOTE: It is not necessary to position or remove the seat in order to remove the DSM.

Position the seat to the highest and most-rearward position to increase the ease-of-access to the DSM.

3. Disconnect the DSM electrical connectors.

4. Remove the 2 bolts and the DSM.

5. To install, reverse the removal procedure.