Sunroof / Moonroof: Adjustments

Roof Opening Panel Alignment

Roof Opening Panel Alignment Specifications





Rear Fixed Glass Panel

NOTE: The roof opening panel motor(s) must be initialized when repairs are carried out on any part of the roof opening panel system, including: whenever the roof opening panel sliding glass motor or power shade motor has been removed from the roof opening panel system, the roof opening panel glass has been removed from the roof opening panel system, the roof opening panel assembly has been removed from the vehicle, a new roof opening panel motor has been installed, a new roof opening panel glass has been installed or a new roof opening panel assembly has been installed. For additional information, refer to Roof Opening Panel Motor Initialization Programming and Relearning.

NOTE: If both glass panels are being aligned, align the rear fixed glass panel before aligning the front sliding glass panel.

1. Position the front sliding glass panel to the fully CLOSED position and the power shade to the full OPEN position.

2. Loosen the 6 rear fixed glass panel screws.

3. Adjust the rear fixed glass panel to specifications.

4. Tighten the 6 rear fixed glass panel screws to 5 Nm (44 lb-in).

Front Sliding Glass Panel

5. Position the front sliding glass panel to the fully CLOSED position and the power shade to the full OPEN position.

6. Loosen the 4 front sliding glass panel screws.
- To access the glass screws, unclip the top portion of the concertina blind and slide the concertina blind rearward as necessary.

7. Adjust the front sliding glass panel to specifications.

8. Tighten the 4 front sliding glass panel screws to 5 Nm (44 lb-in) and make sure the concertina blind is clipped correctly back in place.

9. Initialize the front sliding glass panel motor. For additional information, refer to Roof Opening Panel Motor Initialization Programming and Relearning.