Pinpoint Test K: DTC U0158:00
Cruise Control
Pinpoint Tests
Pinpoint Test K: DTC U0158:00
Normal Operation
- DTC U0158:00 (Lost Communication With Head Up Display: No Sub-Type Information) - sets in the Cruise-Control Module (C-CM) if data messages received from the Head Up Display (HUD) module over the High Speed Controller Area Network (HS-CAN) are missing. For a complete list of all network messages, refer to Information Bus.
This pinpoint test is intended to diagnose the following:
- HUD module
- C-CM
PINPOINT TEST K: DTC U0158:00
-------------------------------------------------
K1 VERIFY THE CUSTOMER CONCERN
- Ignition ON.
- Verify that there is an observable symptom present.
- Is an observable symptom present?
Yes
GO to K2.
No
The system is operating normally at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.
-------------------------------------------------
K2 CHECK THE COMMUNICATION NETWORK
- Ignition ON.
- Enter the following diagnostic mode on the scan tool: Network Test.
- Carry out the network test.
- Does the HUD module pass the network test?
Yes
GO to K3.
No
REFER to Information Bus, The HUD Module Does Not Respond To The Scan Tool.
-------------------------------------------------
K3 RETRIEVE THE RECORDED DTCs FROM THE C-CM SELF-TEST
- Check for recorded DTCs from the C-CM self-test.
- Is DTC U3003:16 or DTC U3003:17 recorded?
Yes
GO to Pinpoint Test Q (U3003:16) or GO to Pinpoint Test R (U3003:17). Pinpoint Test Q: DTC U3003:16 Pinpoint Test R: DTC U3003:17
No
GO to K4.
-------------------------------------------------
K4 RECHECK THE C-CM DTCs
- Clear the DTCs. Repeat the C-CM self-test.
- Is DTC U0158:00 still present?
Yes
INSTALL a new Head Up Display (HUD) module. REFER to Fire Suppression System. CLEAR the DTCs. REPEAT the C-CM self-test.
If DTC U0158:00 is still present, INSTALL a new C-CM. REFER to Cruise-Control Module (C-CM) Service and Repair. TEST the system for normal operation.
No
The system is operating correctly at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.
-------------------------------------------------