Steering Wheel: Service and Repair

Steering Wheel









Removal and Installation

NOTICE: Do not allow the clockspring to rotate while the steering wheel is disconnected or damage to the clockspring may result. If there is evidence that the clockspring has rotated, the clockspring must be recentered. For additional information, refer to Restraint Systems.

1. Remove the driver air bag module. For additional information, refer to Restraint Systems.

2. Remove and discard the steering wheel bolt.
- To install, tighten to 47 Nm (35 lb-ft).

3. Remove the steering wheel.
- Disconnect the steering wheel switches electrical connector from the clockspring.

- Route the 2 driver air bag module electrical connectors and harness through the steering wheel.





4. Tape the clockspring center rotor to the outer housing to keep it from rotating.





5. To install, reverse the removal procedure.
- If installing a new steering wheel, transfer parts as needed. For additional information on the paddle shifters, refer to Automatic Transmission/Transaxle.

6. Install the driver air bag module. For additional information, refer to Restraint Systems.