Washer Pump

Washer Pump





Removal and Installation

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.

2. Remove the front lower air deflector. For additional information, refer to the Front Bumper Exploded View in Bumper.

3. Remove the RH front fender splash shield.

4. WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice. In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury.

NOTICE: When installing a new washer pump, be careful not to damage the rubber grommet.

NOTE: To prevent spilling windshield washer fluid, drain the washer reservoir before washer pump removal.

Remove the washer pump in the following sequence.

1. Disconnect the electrical connector.

2. Disconnect the washer hose.

3. Remove the washer pump.

5. NOTICE: Do not operate the washer pump prior to filling the washer reservoir. Failure to follow this instruction may result in premature washer pump failure.

To install, reverse the removal procedure.

- Fill the washer reservoir with windshield washer fluid.