Seat Cushion - Rear

Seat Cushion - Rear









Removal and Installation

1. From under the front of the cushion assembly, push the 2 cushion floor latch release levers toward the driver side, while lifting up and disengage the front of the cushion assembly.





2. Remove the cushion assembly in the following sequence.

1. Push the cushion assembly back as far as possible.

2. Lift up and pull out at the rear outboard ends of the cushion assembly, disengaging the cushion assembly wires from the retainer hooks.

3. Pull the cushion assembly forward.

4. Disconnect the heated seat electrical connector.

5. Remove the cushion assembly.

3. To install, reverse the removal procedure.
- Make sure the safety belt buckles are accessible to the occupants after installation.