Antenna - Satellite Radio

Antenna - Satellite Radio

NOTE: Combination AM/FM/satellite antenna shown, others similar.











Removal and Installation

NOTE: This procedure applies to the stand-alone satellite radio antenna, the combination AM/FM/satellite radio antenna, and the combination satellite radio/Global Positioning System (GPS) antenna.

1. Remove the LH and RH assist handles.

2. Remove the LH and RH C-pillar trim panels.

3. Carefully lower the rear of the headliner to gain access to the satellite radio antenna.

4. Loosen the satellite radio antenna cable bolt and disconnect the cable from the antenna.
- To install, tighten to 8 Nm (71 lb-in).

5. Remove the antenna.
- Remove the antenna mast, if equipped.

- Press the 2 tabs and remove the satellite radio antenna.

6. To install, reverse the removal procedure.