Selector Lever Bezel

Selector Lever Bezel - MKZ









Removal

1. Remove the LH and RH console finish moldings.





2. Slide the selector lever knob lower bezel down to expose the 2 selector lever knob screws.





3. Remove the 2 selector lever knob screws and remove the selector lever knob.





4. Lift the arm rest, apply the emergency brake, pull directly up on the selector lever bezel and remove it from the center console.





5. Disconnect the selector lever bezel electrical connector and remove the selector lever bezel.





6. Compress the retention tabs on the selector lever boot and remove the boot from the bottom of the selector lever bezel.





7. Compress the retention tabs on the selector lever trim ring and remove the trim ring through from the top of the selector lever bezel.





Installation

1. Install the selector lever trim ring in the selector lever bezel.





2. NOTICE: When installing the selector lever boot, be sure it is in the correct position or the selector lever boot can not be installed on the selector lever knob. If needed, align the selector lever knob to the selector lever boot when installing the boot.

Install the selector lever boot in the selector lever bezel.





3. Position the selector lever bezel in place and connect the electrical connector.





4. Position the selector lever bezel in place and install it onto the center console.





5. Position the selector lever knob onto the selector lever and install the screws.





6. Slide the selector lever knob bezel up and install it on the selector lever knob.





7. Install the LH and RH console finish moldings.