Ignition Switch: Service and Repair

Ignition Switch

Removal and Installation

NOTE: Steering wheel removed for clarity.











1. Depower the Supplemental Restraint System (SRS). For additional information, refer to Restraint Systems.

2. Remove the steering column tilt release lever/handle.





3. NOTE: Release the upper steering column shroud by pressing the sides inward.

Remove the 3 screws and the upper and lower steering column shrouds.

- To install, tighten to 2 Nm (18 lb-in).

4. Remove the ignition switch.

1. Disconnect the electrical connector.

2. Remove the ignition switch screw and remove the ignition switch.
- To install, tighten to 5 Nm (44 lb-in).

5. To install, reverse the removal procedure.

6. Repower the SRS. For additional information, refer to Restraint Systems.